Concrete you can drive, walk and build on in Kingsland, GA

The price depends on the size of the driveway, whether an old one has to be torn out and hauled off, how much base work the ground needs and the finish you pick. A plain broom finish costs less than stamped or colored concrete. After I see the site, I'll put your figure in a written estimate.

Usually the cheaper quote leaves something out, most often base work, removal, drainage or steel reinforcement. The base, the packed ground the slab sits on, is hidden the day we pour, so it's the first thing a tight budget cuts. I'd spend there before spending on a fancier finish, because a slab on loose dirt settles and cracks right along with it.

You can usually walk on new concrete well before you can drive on it, and I'll tell you the wait for your slab before we pour. Curing is the time concrete needs to harden and gain strength, and putting weight on it early can crack or mark it. Tear-out, base work and the weather also move the schedule.

Yes, Georgia requires residential contractors to hold a state license and carry insurance. The state board sets general liability coverage of at least $300,000 for a residential-basic license and $500,000 for residential-light commercial, plus workers' comp. Kingsland's permit office also checks contractor licensing when it reviews a project.

I come out to your property myself, measure the job, look at the grade and where water runs, and write an estimate that shows what's included. Once you're ready, we confirm which office covers your address. Inside Kingsland, that's the city's Housing and Development Department, which issues building permits and inspects work for code.

Yes, our promise on every job is "Your satisfaction, guaranteed." I'm on site with our crew, so the job gets built the way I measured it. Before we pour, I'll also walk you through what's normal for new concrete, like small hairline cracks, so nothing about the finished work catches you off guard.

Most concrete gets some small cracks over time, but a slab on a packed base with joints cut on time usually keeps them small and where we planned. Control joints are shallow grooves cut into the slab that give it a straight place to crack. Old slabs usually crack and sink because the base was only raked level, water ran toward them or the joints were skipped.

Yes, the city says Kingsland is subject to flooding from surrounding rivers because it sits in low-lying coastal plains, and hurricanes can bring storm surge and inland flooding. That's why we check where water runs before we set a grade, so the slab sheds water away from your house. The city's Planning and Zoning office can help with flood zone and elevation questions for your property.